Get the latest updates available for your computer's operating system, software, and hardware. We will scan your computer and provide you with a selection. Please provide a copy of your System Information file. To access your System Information file select the keyboard shortcut Win+R, type msinfo32 and press the ENTER key. Select File, Export and give the file a name noting where it is located. Do not place the cursor within the body of the report before exporting the file. Ms-sys is a Linux program for writing Microsoft compatible boot records. The program does the same as Microsoft 'fdisk /mbr' to a hard disk or 'sys d:' to a floppy or FAT partition except that it does not copy any system files, only the boot record is written. If your Microsoft ME operating system won't work anymore, buy a upgrade package off ebay that converts your o/s to XP home. Yes, it works OK and allows you to keep your current computer a few more. Microsoft Digital Sound System 80 HID Audio Controls. Download.com cannot completely ensure the security of the software hosted on third-party sites. The sound system is Microsoft's why.
Active1 year, 6 months ago
I have an old MS-DOS computer that I am experimenting with. The computer has an AMD 80386 processor, 1664 KB of RAM, a 50 MB hard drive, and two floppy disk drives: one 3 1/2 inch, the other 5 1/4 inch.
I am in the process of installing a C++ compiler on this computer (see Install C++ compiler on old MS-DOS computer with floppies for more details). In order to facilitate that installation, I am attempting to install a CD-ROM drive. The drive is a Top Glory Electronics BCD G621D. I have found the correct driver (http://www.driverguide.com/driver/detail.php?driverid=349099) and have followed the instructions in the manual (included in the driver download) to connect the drive to the system and install the software.
Currently the CD-ROM drive is hooked up as a slave drive to the HD, and the jumper is set accordingly. The drive is being powered correctly; it opens and closes as it should.
The driver is installed in D:CDROM, while the MS-DOS system files are located in the C: drive. I have added the following lines to the CONFIG.SYS and AUTOEXEC.BAT files, respectively:
and
The former loads the driver into memory, and the latter configures the MSCDEX.EXE program to interact with the driver, thus allowing the user (me) to access the CD-ROM drive.
However, a problem has occurred. After installing the driver and restarting the system, one of two things happen: 1. Information about the driver is displayed. 2. An unusually large cursor flashes on-screen.
The information mentioned in item 1 is shown here:
In both cases, the DOS prompt never appears, and the system does not accept commands. Thus, the computer is rendered useless.
The problem appears to be caused by the line in CONFIG.SYS. When I boot MS-DOS from a floppy disk rather than the HD and remove that line from the file, the computer works just fine when I reboot from the HD. (Of course, MSCDEX.EXE cannot access the device, as the driver is not loaded).
This leads me to believe that I have the drive and its driver set up correctly. However, that does not help me considering that I am unable to do anything with the computer once the driver loads. Does anybody know how I would be able to gain access to the MS-DOS prompt and use the computer while the driver is loaded?
Thanks in advanced for your help.
Community♦
KyleKyle
5 Answers
I think the clue is in the description box. Odds are, the sound card has an IDE port on it. Many, if no most of them do. Usually it can be disabled by a jumper on the sound card. You could temporarily remove the sound card. Or you could connect the cd drive to the sound cards IDE port.
KneepuckKneepuck
Try using the Oak CD-ROM driver here. Make sure you add
HIMEM.SYS as it directs.
Your system dates from the era when there were often issues with slaving two devices on a single IDE port that weren't from the same manufacturer and didn't explicitly support it. If you still encounter problems, attach to the other IDE port if your motherboard has one, or look on your favorite auction site for an ISA IDE adapter and see if you have better luck with that.
LawrenceCLawrenceC
61.6k1212 gold badges109109 silver badges187187 bronze badges
I am going to go another direction. Simply rem out the line in the config.sys file that loads cdrom.sys and reboot. If you get a DOS prompt at that point then it is the cdrom.sys and you need to find a different one.
https://appskeen941.weebly.com/marvel-heroes-free-download.html. Just what you see on the screen:
Example : DEVICE=CDROM_DRV.SYS /D:MSCD001 [/DMA]/DMA --> Enable PCI Bus Master DMA Mode/UDMA --> Enable PCI Bus Master Ultra DMA Mode
https://appskeen941.weebly.com/autodesk-inventor-2016-book-pdf.html. is almost telling you that the command line isn't right. mscdex won't work with the cdrom.sys remed out but it won't affect anything.
I agree with the pause as the first line in the autoexec.bat to see just what the config.sys file did.
It is a very simple way to determing if the cdrom.sys is causing the problem..
ZiggyStardustZiggyStardust
I agree with the comment about removing MSCDEX from AUTOEXEC.BAT.
Maybe not a long term solution, but that could help to determine where the stability issue exists.
Try making the first line of AUTOEXEC.BAT this:
And the second line this:
If the problem is the CONFIG.SYS driver, try changing it. I don't know just what DriverGuide offered you, but there are some drivers that tended to work on almost all drives, and use up far less conventional memory than most other CD drivers. See:TOOGAM's Software Archive: CD drivers for DOS for details. Because conventional memory was often important in DOS, I would be fairly try those drivers in just about any case, even if official manufacturer's drivers weren't causing stability issues. Confix.sys can also be useful, allowing you to echo messages and pause bootup during config.sys processing. This may really help you confirm that the config.sys line is what is causing stability issues.
If you're using MS-DOS 6 (or perhaps newer alternatives, like FreeDOS), then try holding F8 or Shift-F8 when booting. You may find that's an easier way to skip lines from the CONFIG.SYS file.
Your sample config.sys output shows quite a lot of IRQ info. Hardware conflicts can cause symptoms like what you describe: where the second time the computer boots then things don't initialize as desired. If you continue to have problems with different drivers, make sure that there's no conflicts of I/O address or IRQs (or DMA). That was a common source of problems with computers in that era, and can typically be fixed for free by just figuring out what hardware (or possibly driver) needs to have settings be changed.
Hennes
60k77 gold badges9494 silver badges143143 bronze badges
TOOGAMTOOGAM
11.8k33 gold badges2626 silver badges4949 bronze badges
Myxer free ringtones mp3. This behavior can occur if any of the following conditions exist:
To access a CD-ROM drive when you boot to a Windows command prompt or restart the computer in MS-DOS mode, you must load the real-mode CD-ROM driver in the Config.sys file and the MSCDEX driver in the Autoexec.bat or Dosstart.bat file. If your CD-ROM drive is supported in protected mode in Windows, the real-mode CD-ROM and MSCDEX drivers are most likely not being loaded in the Config.sys and Autoexec.bat or Dosstart.bat files on the hard disk. In addition, if you boot from a floppy disk, the CD-ROM and MSCDEX drivers will not load unless you manually configure the Config.sys and Autoexec.bat files on the floppy disk to load them.
for resolve them see :
mohammad moeinimohammad moeini
Not the answer you're looking for? Browse other questions tagged driverscompact-discms-dos or ask your own question.
Office 2007 include applications such as Word, Excel, PowerPoint, and Outlook. They’re available as a one-time purchase for use on a single PC.
Office 365 plans include premium versions of these applications plus other services that are enabled over the Internet, including online storage with OneDrive and Skype minutes for home use. With Office 365 you get the full, installed Office experience on PCs, Macs, tablets (including iPad® and Android™ tablet) and phones. Office 365 plans are available as a monthly or annual subscription. Learn more.
See system requirements for compatible versions of Windows and macOS, and for other feature requirements.
You don’t need to be connected to the Internet to use Office applications, such as Word, Excel, and PowerPoint, because the applications are fully installed on your computer.
However, Internet access is required to install and activate all the latest releases of Office suites and all Office 365 subscription plans. For Office 365 plans, Internet access is also needed to manage your subscription account, for example to install Office on other PCs or to change billing options. Internet access is also required to access documents stored on OneDrive, unless you install the OneDrive desktop app.
You should also connect to the Internet regularly to keep your version of Office up to date and benefit from automatic upgrades. If you don’t connect to the Internet at least every 31 days, your applications will go into reduced functionality mode, which means that you can view or print your documents but cannot edit the documents or create new ones. To reactivate your Office applications, reconnect to the Internet.
Yes. Documents that you have created belong fully to you. You can choose to store them online on OneDrive or locally on your PC or Mac.
If you cancel your subscription or it expires, you can still access and download all your files by signing in to OneDrive directly using the Microsoft account you used to set up Office 365. You do lose the additional storage that comes with your subscription, so you must save your files elsewhere or buy more OneDrive storage if your OneDrive account exceeds the free storage quota.
All Free Downloads From Microsoft
If you purchase an auto-renew subscription, your subscription starts when you complete your purchase. You can purchase auto-renew subscriptions from Office365.com, MicrosoftStore.com, iTunes®, and some other retailers. If you purchase a pre-paid subscription, your subscription starts when you activate your subscription and land on your My Account page. You can purchase pre-paid subscriptions from a retailer or reseller, or a Microsoft support agent.
Ms-sys Download
If you have an active Office 365 Home subscription, you can share it with up to four members of your household. Each household member you share your subscription with can use any of your available installs on their PCs, Macs, iPads, Android tablets, Windows tablets, iPhones® or Android phones, get an additional 1 TB of OneDrive storage, and manage their own installs from www.office.com/myaccount.
To add someone to your subscription, visit www.office.com/myaccount and follow the onscreen instructions to add a user. Each person you add will receive an email with the steps they need to follow. Once they have accepted and completed the steps, their information, including the installs they are using, will appear on your My Account page. You can stop sharing your subscription with someone or remove a device they are using at www.office.com/myaccount.
“The cloud” is a friendly way of describing web-based computing services that are hosted outside of your home or organization. When you use cloud-based services, your IT infrastructure resides off your property (off-premises), and is maintained by a third party (hosted), instead of residing on a server at your home or business (on-premises) that you maintain. With Office 365, for example, information storage, computation, and software are located and managed remotely on servers owned by Microsoft. Many services you use every day are a part of the cloud—everything from web-based email to mobile banking and online photo storage. Because this infrastructure is located online or “in the cloud,” you can access it virtually anywhere, from a PC, tablet, smartphone, or other device with an Internet connection.
Comments are closed.
|
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |